Adjustable 3D Overlays
When the 3D overlay is not correct, the ability to edit the overlay, rather than deleting it and creating a new one would be more efficient. If you are publishing sheets from Revit and the design team uses funky view ranges, fixing the 3D overlays can be a lot of work.
Great comment here. Just so I understand, you want to adjust the constraints of where the view ranges sit, inside of Revizto. Without having to recreate the entire overlay from scratch. I will definitely make sure this is on the wishlist for future development.
I wonder if it would be more efficient to ask the designers to use associated level in the view ranges to clean it up at the time of export.
You are correct in what I am asking.
In terms of asking designers to fix their models. Unless the project would be design-build for us, it is very unlikely that the designer would make such a change at our request. I am also guessing that they set the view range to address a specific need on their part, so making an adjustment would be even more of an obsticle.
This also should apply to manually created sheet overlays. Currently if you have gone through the entire process of manually overlaying say a PDF sheet and you want to simply expand the view extents (maybe step 1 wasn't quite right) you have to "Delete all overlays" and start again.
This would be even more time consuming is you have mulitple view overlays manually created on a single sheet as you'd have to remove ALL and start again.
Request - allow for changes to a view overlay (either view extents / overlay position / view range) dynamically without having to start from scratch to change any one of these settings.
Please sign in to leave a comment.